Chassis Configuration Settings
GARD 8000 SYS RFL Electronics
April 1, 2012 7-23 973.334.3100
This indicates the number of seconds in which any number of CRC errors were detected since the last
reset of this counter. This counter can max-out.
Bit Error Rate
This indicates the percentage of received bits in error compared to the total number of bits received.
This rate is an approximate value calculated from messages with CRC failures. As CRC detection
does not indicate the number of errors in a bad message, bit error rates above 1E-3 cannot be
accurately measured. This value is updated every 10 seconds based on the previous 110 seconds of
data. As there are only 7E 6 bits in 110 seconds, error rates less than 1E-6 cannot be accurately
measured.
Reset Error Counters
Click on this button to reset to zero: CRC errors per second, CRC errored seconds, and CRC
accumulated errors, for this TPS channel.
Ping Pong (ms)
Indicates the last ping pong (one-way channel delay) time in milliseconds.
Rx Address
Enter the receiver address for this TPS channel, between 0 and 255.
Major Hardware Alarm
This is a status indication, which can be either Red or Green. Currently this card does not report Major
Hardware Alarms, and therefore this indication will always be green
Tx Direction
This is a status indication, which can be either A or B. In TPS the Tx Direction is forced to transmit on
Bus B. TPS will always transmit data on the B Bus.
Rx Direction
This is a status indication, which can be either A or B. In TPS the Rx Direction is forced to receive on
Bus A. TPS will always receive data from the A Bus.
Select save to enter the changes from the TPS channel configuration page.
To Next Page