Chassis Configuration Settings
GARD 8000 SYS RFL Electronics
April 1, 2012 7-28 973.334.3100
96-Bit TPS Channel 1 at slot #1 Front Definitions
User Label
This is where the user can change the channel name.
Comms Head Label
Displays the label given to the communications head associated with the TPS channel.
Time Slot
Displays the time slot the TPS channel will communicate on.
Channel Service
This is a status indication that the TPS channel is either Enabled and In Service, or Disabled. The
Channel Service is automatically enabled once the user selects the Comms. Head and Timeslot in the
Communications Time Slot Page and clicks on the Save button.
CRC Errors Per Second
This indicates of the number of CRC errors detected in the previous second. A maximum of 421
messages can be received per second in error. This will give the user the current condition of the
channel. This will cover all the bits of the 152 bit message except for the 8 bit frame.
CRC Errored Seconds
This indicates the number of seconds in which any number of CRC errors were detected since the last
reset of this counter. This counter can max-out.
Reset Error Counters Button
Click on this button to reset to zero: CRC errors per second, CRC errored seconds, for this TPS
channel.
Bit Error Rate
This indicates the percentage of received bits in error compared to the total number of bits received.
Ping Pong Limit
Can be set from 1 to 31 ms. Enter the one-way channel delay threshold, which must be exceeded for
alarms to be indicated.
Ping Pong (ms)
Indicates the last ping pong (one-way channel delay) time in milliseconds.
Tx Address
Enter the transmitter address for this TPS channel, between 0 and 255.
Rx Address
Enter the receiver address for this TPS channel, between 0 and 255.
96-Bit TPS Channel 1 at slot #1 Front Definitions (continued)
To Next Page
Loading...