Chassis Configuration Settings
GARD 8000 SYS RFL Electronics
April 1, 2012 7-55 973.334.3100
Chan 1 through Chan 4 State
Channel 1 - 4 can be Enabled or Disabled
Chan 1 through Chan 4 Transmit On
The indicator will be GREEN if the channel 1 - 4 transmitter is on.
The indicator will be RED if the channel 1 - 4 transmitter is off.
Chan 1 through Chan 4 Transmit State
The current status of the channel 1 - 4 transmitter.
Can be High Frequency, Low Frequency, or Blank.
Chan 1 through Chan 4 TX Boost
Channel 1 - 4 Tx Boost can be Active or Inactive.
Channel Status Web Page definitions for column 2
Chan 1 through Chan 4 receive On
The indicator will be GREEN if the channel 1 - 4 receiver is on.
The indicator will be RED if the channel 1 - 4 receiver is off.
Chan 1 through Chan 4 RX State
The actual channel 1 - 4 received status. Can be High Frequency, Low Frequency, or Blank.
Chan 1 through Chan 4 Noise Detectors
The actual channel 1 - 4 received noise detection status.
Can be Normal, AM Noise, FM Noise, or AM and FM Noise
To Next Page
Loading...