Chassis Configuration Settings
GARD 8000 SYS RFL Electronics
April 1, 2012 7-70 973.334.3100
PLC General Status Definitions (continued):
RX Carrier Alarm
Indicates whether the RX carrier is in alarm mode.
Transmitter State
Indicates the transmitter state.
Receiver State
Indicates the receiver state.
FSK Only
SNR
Reports the Signal To Noise Ratio of the RX signal in dB.
SNR Alarm (Channel Fail)
Reports an SNR (Signal to Noise Ratio) Alarm as follows: Channel OK, or Channel Fail
Reflected Power
Reports the reflected power in percent.
Reflected Power Alarm
Reports a reflected power alarm as follows: Alarm or No Alarm.
Trans Hybrid Loss
Reports the Trans Hybrid Loss in dB.
ON-OFF Only
Checkback Mode
Reports the checkback mode that is in use as follows: Master, Remote or Disabled.
Checkback Status
Reports status of the last checkback test as follows:
Not Yet Performed
Passed
Test X Failed (Where X is the number of the test, X can be 1 to 8)
Version Info.
Rear Board ID
Indicates the ID of the Rear Board.
PLC Software Version
Reports the PLC software version starting at 1.
To Next Page
Loading...