Tests and Diagnostics
GARD 8000 SYS RFL Electronics
February 14, 2011 11-5 973.334.3100
Bus:
Indicates the logic state from the input module to the bus. This may be different from the field if any
other state than Normal is selected in the mode function above.
Test:
Indicates the mode of the function. Because the mode does not change until the execute test button is
pressed the Test column indicates what the present mode of the input function is, the mode column will
represent what mode the input function will change to after the execute test button is pressed. The
background of the test field will be red for any function that is not in Normal mode.
Status indicators:
There are four module status indicators as follows:
Configured:
This will be green if the module has been configured after initial installation into the chassis
and red if the module has not been configured.
Enabled:
This will be green if the module is enabled and red if it is disabled.
Major Alarm:
If the module is in a major alarm condition this indicator will be red, otherwise this will be
green indicating a non-alarmed condition.
Minor Alarm:
If there is a minor alarm or whenever any function is in a state other than Normal the Minor
alarm indicator will be yellow. During normal conditions this indicator will be Green.
To Next Page
Loading...