Tests and Diagnostics
GARD 8000 SYS RFL Electronics
February 14, 2011 11-40 973.334.3100
Audio Protection Test Definitions:
Station Label
Indicates the assigned Station Label.
Logic Bus Outputs
Can Be set to Normal or Disable. Allows a user to disable the logic bus drivers in the Audio Tone
module.
Internal loopback
Can be set to Normal or Enable. Allows a user to enable loopback tone signals inside the Audio Tone
module.
Chan 1 Tx State
Indicates the Channel 1 Tx State as follows: Modem, High Frequency, Low Frequency or Disabled.
Chan 1 Rx State
Indicates the Channel 1 Rx State as follows: Modem, High Frequency, Low Frequency or Disabled.
Chan 2 Tx State
Indicates the Channel 2 Tx State as follows: High Frequency, Low Frequency or Disabled.
Chan 2 Rx State
Indicates the Channel 2 Rx State as follows: High Frequency, Low Frequency or Disabled.
Chan 3 Tx State
Indicates the Channel 3 Tx State as follows: High Frequency, Low Frequency or Disabled.
Chan 3 Rx State
Indicates the Channel 3 Rx State as follows: High Frequency, Low Frequency or Disabled.
Chan 4 Tx State
Indicates the Channel 4 Tx State as follows: High Frequency, Low Frequency or Disabled.
Chan 4 Rx State
Indicates the Channel 4 Rx State as follows: High Frequency, Low Frequency or Disabled.
Modify Channel 1 Tx
Four selections are available as follows:
1) Normal: Channel 1 transmitter is operating normally.
2) Low: Channel 1 will transmit at the lower configured frequency.
3) High: Channel 1 will transmit at the higher configured frequency.
4) Off: Channel 1 transmitter is off.
To Next Page