Tests and Diagnostics
GARD 8000 SYS RFL Electronics
February 14, 2011 11-42 973.334.3100
Audio Protection Test Definitions (continued):
Remote Chan 2 Rx State
There are five possible Chan 1 Rx States as follows:
1) Low Freq: Remote receiver is receiving lower configured frequency.
2) High Freq: Remote receiver is receiving higher configured frequency.
3) Not Active: No tones are being received.
4) Disabled; Remote channel 1 receiver is disabled.
5) Modem Fail: Modem is not functioning.
Remote Chan 2 Rx Level
Displays the Remote Chan 2 receiver level in dB.
Remote Chan 3 Rx State
There are five possible Chan 1 Rx States as follows:
1) Low Freq: Remote receiver is receiving lower configured frequency.
2) High Freq: Remote receiver is receiving higher configured frequency.
3) Not Active: No tones are being received.
4) Disabled; Remote channel 1 receiver is disabled.
5) Modem Fail: Modem is not functioning.
Remote Chan 3 Rx Level
Displays the Remote Chan 3 receiver level in dB.
Remote Chan 4 Rx State
There are five possible Chan 1 Rx States as follows:
1) Low Freq: Remote receiver is receiving lower configured frequency.
2) High Freq: Remote receiver is receiving higher configured frequency.
3) Not Active: No tones are being received.
4) Disabled; Remote channel 1 receiver is disabled.
5) Modem Fail: Modem is not functioning.
Remote Chan 4 Rx Level
Displays the Remote Chan 4 receiver level in dB.
Reset Date and Time
Indicates the Date and Time that the Reset Counter was reset to zero.
Remote Address Expected
Displays the expected remote address.
Remote Address Received
Displays the received remote address.
To Next Page