Tests and Diagnostics
GARD 8000 SYS RFL Electronics
February 14, 2011 11-54 973.334.3100
Reset Oscillography
Check this box to clear the oscillography records saved in the relay (See 13.4.8). Click Run Test.
Reset SOE
Check this box to clear the SOE records saved in the relay (See 13.4.7). Click Run Test.
Local Test Mode Active
When red this indicates that the local relay is in test mode (see section 13.5.2.1). Green indicates that
the local relay is not in test mode.
Force Oscillography Record
Check this box to force an Oscillography Record to be written (see section 13.4.8).
Force SOE Record
Check this box to force a SOE Record to be written (see section 13.4.7).
Remote Test Mode Active
When red this indicates that the remote relay is in test mode (see section 13.5.2.1). Green indicates
that the remote relay is not in test mode.
Local Test Mode Command
When red this indicates that the local relay was commanded to enter test mode and will be blocked
from tripping the breaker. Green indicates that the local relay is not in test mode.
Remote Test Mode Command
When red this indicates that the remote relay was commanded to enter test mode and will be blocked
from tripping the breaker. Green indicates that the remote relay is not in test mode.
The following will give the listed components installed version.
Relay ACTEL Firmware Ver
Relay Board Ver
I/O ACTEL Firmware Ver
I/O Hardware Ver
Current Diff DSP Rev
HMI Interface Ver
To Next Page
Loading...