Installation and Commissioning
GARD 8000 SYS RFL Electronics
November 28, 2017 4-28 973.334.3100
Verifying Output Mapping
Outputs can be mapped to different points in the logic. Output mapping choices are set up in
the logic database and are loaded during a System Logic Database TXT upload. The file for
default logic provides a series of choices for mapping 2 output cards to various points which
are tied to 8 functions of a TPS module. From the toolbar select ‘Settings’, ‘System Logic
Configuration’ and then ‘Output Mapping’. A screen similar to the one below will appear.
If a hardware output is mapped to NOT USED, that hardware output will not be tied to the
logic, and will not operate under any situation.
4.6.1.6 PERFORMING SOFTWARE INPUT/OUTPUT TESTING
Now that operation of the communication channel, and Input/Output Mapping have been verified, the
functionality of the ‘MAPPED’ INPUTS/OUTPUTS can be tested via the software.
1. Click on ‘System Test’ at the Test Menu.
2. In the System Test Menu select the appropriate Input Module that was configured and had its
inputs mapped.
3. Select ‘Active’ option for the Inputs selected for the testing.
4. Click on ‘Execute Test’
5. Verify that ‘Logic 1’ is being placed on the Bus for the inputs under test.
6. At the same time, go to the Output Test menu and verify ‘Logic 1’ under ‘Bus’ and ‘Field.’
7. Use an Ohm Meter to verify an operation of the appropriate outputs.
8. Set all inputs back to Normal.
To Next Page
Loading...