1001 Bit Switch
bit 6 Color balance switching 0:Disabled 1:Enabled
This BitSwitch can be used to restore the color balance to match that of previous
models. If this BitSwitch is set to "1" (Enabled), the color balance that is equivalent to
Fuji-Xerox printers will be used.
bit 7 [RPCS,PCL]: Printable area frame border 0: Disable 1: Enable
Prints all RPCS and PCL jobs with a border around the printable area.
1001 Bit Switch
002 Bit Switch 2 0 1
bit 0
Color balance switching Disabled Enabled
This BitSwitch can be used to restore the color balance to match that of previous
models. If this BitSwitch is set to "1" (Enabled), the color balance from 09S and
earlier models will be used.
bit 1 DFU - -
bit 2 DFU - -
bit 3 [PCL5e/c.PS]: PDL Auto Switching 0: Enable 1: Disable
Enables/disable the MFPs ability to change the PDL processor mid-job.
Some host systems submit jobs that contain both PS and PCL5e/c. If Auto PDL
switching is disabled, these jobs will not be printed properly.
bit 4 Color balance switching Disabled Enabled
This BitSwitch can be used to restore the color balance to match that of previous
models. If this BitSwitch is set to "1" (Enabled), the color balance from 09A and
Extended 09A models will be used.
bit 5 DFU - -
bit 6 Switch dither 0: Use
normal
dither
1: Use
alternative
dither
See RTB#RD014018.
bit 7 DFU - -
Printer Service Mode
245
To Next Page
Loading...
