5. Turn the power ON.
6. Wait for the machine to beep twice.
7. Enter the SP mode and select SP2-012-001 (Initial Operation Setting). Make sure that it is
set to "9".
• SP2-012-001
• This SP code is used to modify the initial ink filling sequence at installation and after one
• or more print heads have been replaced. Every time the machine is turned on, the machine
checks the ink level in each sub tank. If ink is low, then the machine switches on
• the ink pump motor(s) to fill the tank(s).
8. Next, set SP2-100-004 (Special Maintenance: Extract Filling Liquid) to "31" and then
touch [#] and [EXECUTE].
• SP2-100-004
• Press [EXECUTE] to drain the primer fluid from the print heads, print head sub tanks, and
• ink supply tubing. This is done at installation before the ink cartridges are installed.
• Special cartridges are provided to hold the drained fluid.
• This SP is used only at installation before the print heads are filled with ink.
• The ink pumps start operating in reverse to draw the fluid out of the print head units and the
tubes.
• Draining the fluid requires about 7 min. and 48 sec.
The procedure is finished when a message tells you the procedure has completed. The machine
disables the cartridges so that they can no longer be used.
Main Machine Installation
127
To Next Page
Loading...
