• To check for completion of an operation with SP, specify SP2-030-001 (Extract Filling Liq
Prog Mng: Completed State Flag). If the operation is completed, "00011111" will be
displayed for that SP.
• If the draining operation does not start, go to the next section below for more about an
alternative procedure.
9. Turn the power OFF.
10. Remove the primer fluid drain cartridges and replace them with the starter ink cartridges.
• Load the cartridge securely until the lever clicks. Otherwise the fluid may spill inside the
machine.
11. Close the cartridge cover.
12. Turn the power ON.
• The ink filling sequence will start automatically.
• The ink filling requires about 13 min and 42 sec.
• After filling, the machine may display the pre-near end alert for one or more of the color ink
cartridges. This is normal.
• If you do not see a message that tells you filling has started, cycle the power OFF/ON and try
again.
13. After the procedure is completed, open SP2-012-001 (Initial Operation Setting) and
confirm that it displays "0".
• SP2-012-001
2. Installation
128
To Next Page
Loading...
Need help?
General
