• Last of all, place the ink tube (M2) upon the ink tube (Y2) on the path of the print head. [E]
15. Attach the carriage unit cover.
For attaching the carriage unit cover, perform the procedure for removing in reverse order. (Print
Head Unit)
• To attach the carriage upper cover, move the harness to the HRB so that no pressure is
applied to the ink tube.
• 1: HRB
• 2: Electrode pin harness
• 3: Thermistor
• 4: Head tank
• Keep extra length of the thermistor harness above the carriage front cover line as shown in the
illustration below.
Carriage Unit
461
To Next Page
Loading...
