pcodes.fm
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
A-1
System Programming Codes (Expert Mode Codes)
A System Programming Codes (Expert Mode Codes)
Introduction
You can administer HiPath 3000 systems from an optiset E or optiPoint 500 telephone (with dis-
play) using expert mode at either of the first two stations (U
P0/E
). You can initiate expert mode
by entering a sequence of consecutive digits that branch you to the desired option.
Error message displays
You must acknowledge error messages. When the system reports an error as a result of enter-
ing a previously used code, the expert mode code appears at the beginning of the second line
of the display. You can use the expert mode code to go directly to the desired menu segment.
Menu selection using codes
Depending on the menu you enter either single-digit or multi-digit codes. You can use "*" on the
numeric keypad to change the item and "#" to invoke the configuration option.
Accessing system administration
Users can access system administration by entering a user name (ID) and password (authen-
tication). Depending on the active password concept (refer to Section 12.6.1.1 for more details),
the procedure is as follows:
For an example of the first time system administration is called via Assistant T after the system
is booted, refer to Page 12-79.
Table A-1 Starting System Administration (Service)
Step Entry Description
1. *95 Start system administration
2. XXXXX Enter user name:
● Fixed password concept: User name = 31994
● Variable password concept: Individual user name
3. XXXXX Enter password:
● Fixed password concept: Password = 31994
● Variable password concept: Individual password
To Next Page
Loading...
Need help?
General