Starting Up HiPath 3000
P31003-H3550-S403-4-7620, 02/05
5-26 HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
start_h3.fm
Starting Up HiPath 3550, HiPath 3350, HiPath 3500, HiPath 3300
5.4.6 Customer-Specific Programming
You can program the system using one of the following tools:
● Assistant T (programming telephone, refer to Appendix A)
● HiPath 3000 Manager E (PC tool)
Refer to the HiPath 3000 Manager E Help for information on programming individual features.
5.4.7 Performing a System Check
Checking the telephones
● Check the time and date display on each telephone. If a display does not appear, either the
telephone or the link is defective. Replace the terminal or fix the link.
● Perform random terminal tests as described in Section 12.3.1.8 on all telephones.
Checking for proper system booting
● Set up internal and external calls at random to check if the system is functioning properly.
>
Changes to the system (for example key programming) made using during an HiPath
3000 Manager E offline programming session will be lost when the database is load-
ed.
When you program the system offline, the assignments of trunk and subscriber ports
depend on the order in which the boards are inserted. Usually, the boards are insert-
ed from the lowest slot to the highest.
To Next Page
Loading...
Need help?
General