inst_h3.fm
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
4-83
Installing HiPath 3000
Installing HiPath 3750, HiPath 3700
4.3 Installing HiPath 3750, HiPath 3700
4.3.1 Installation Prerequisites
Tools and resources needed
The following are needed for installing the HiPath 3750 and HiPath 3700 system:
● Tools:
– Hex or open-end wrench, 8 mm
– Diagonal cutting pliers, telephone pliers, wire stripper, flat-nosed pliers
– Slotted screwdrivers, from 2 to 8 mm (1/4 to 5/16 in.)
– Phillips or cross-point screwdrivers, sizes 1 and 2
–TORX screwdriver
– Wire stripper (for example, from Krone)
– Electric drill, hammer
– Level, tape measure
– For U.S. only: Punch-down tool suitable for the block used (such as block 66)
● Resources:
– Assistant T or HiPath 3000 Manager E
– Digital multimeter for testing ground connections and partial voltages
– Telephone test set for analog interfaces
– Not for U.S.: ISDN tester (such as K3000 or Aurora)
– For U.S. only: Aurora
Duet
, Aurora
Expert,
Aurora
Remote
or similar, ISDN protocol analyzer
7
Warning
Only authorized service personnel should install and start up the system.
To Next Page
Loading...
Need help?
General