Siemens HiPath 3000 Service Manual

sysdat.fm
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
2-27
System Data
Technical Specifications and Compliance to HiPath 3000
2.8.2.1 FCC Compliance
2.8.2.1.1 FCC Rules, Part 15
Each Siemens system discussed in this section, except the HiPath 3350, has been tested and
found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy. If installation and operation are not in line with the instruc-
tions in the manual, this can lead to disruptions in radio communication. Operation of this equip-
ment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at his own expense.
The HiPath 3350 has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a residential instal-
lation. This equipment generates, uses, and can radiate radio frequency energy. If installation
and handling are incorrect, this can lead to disruptions in radio communication However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the distance between the equipment and receiver.
● Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
● Consult the dealer or an experienced radio/TV technician for help.
2.8.2.1.2 FCC Rules, Part 68
Each Siemens system discussed in this section complies with FCC Rules, Part 68. A label on
the outside back of the cabinet identifies the FCC registration number, the ringer equivalence
number (REN), and other information. If requested, this information must be given to the tele-
phone company.
Disruption of the Network and T1
For networked systems using 1.544 Megabits per second (Mbps) T1 service, notify the tele-
communication company when the equipment is disconnected from the network. If any Sie-
mens system discussed in this section disrupts the telephone network, the telecommunication
company can discontinue your service temporarily. If possible, the telecommunication company

Siemens HiPath 3000 Specifications

General

Brand	Siemens
Model	HiPath 3000
Category	Telephone
Language	English