Starting Up HiPath 3000
P31003-H3550-S403-4-7620, 02/05
5-2 HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
start_h3.fm
Starting Up HiPath 3800
5.2 Starting Up HiPath 3800
This section contains information on how to start up the HiPath 3800 communication system.
5.2.1 Startup Procedure
7
Warning
Only authorized service personnel should start up the system.
7
Danger
The system may only be started (connected to the power supply) if all system cabi-
nets are sealed at the rear with the connection and filler panels provided.
Table 5-1 HiPath 3800 - Startup Procedure
Step Startup Activity (Remarks)
1. Supplying the System with Power, page 5-3
(Plugging in the power supply cable for the system cabinet(s) and positioning the
switches for all LUNA2 power supplies to “DC-ON” –> starting system boot)
2. Carrying Out a System Reload, page 5-6
3. Carrying Out the Country Initialization and Selecting the Password Type, page 5-7
4. Not for U.S.: Entering the System Number, page 5-9
5. Customer-Specific Programming, page 5-10
6. Performing a System Check, page 5-10
To Next Page
Loading...
Need help?
General