Siemens HiPath 3000 Service Manual

exup.fm
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
9-31
Expanding and Upgrading HiPath 3000
Upgrading HiPath 3000 to V5.0
9.3.2 Software Upgrade
If the software is a version earlier than V3.0, it must first be upgraded to V3.0. Only then is it
possible to upgrade the software to V5.0.
CDB conversion is also necessary.
Procedure: Customer database (CDB) conversion
>
Please note the following:
S
0
stations can be configured as both HFA clients and vCAPI clients in V4.0. In ad-
dition, V4.0 does not have a selected gatekeeper board. This configuration will have
to be re-defined when upgrading to V5.0 (see Figure 9-15).
The flowchart on Page 9-32 describes the procedure for converting the CDB from
V4.0 to V5.0. First, you must edit the V4.0 CDB. Then you must convert the CDB and
finally, edit the V5.0 CDB.
No other changes are necessary apart from modifications for IP workpoint clients
and IP lines. Only the gatekeeper and gateway data has to be edited. Telephone
numbers and other properties of the IP workpoint clients are retained. The protocol
has to be modified for the IP lines.
Figure 9-15 Differences Between V4.0 and V5.0 Configurations
HG 1500 board
slot 4
S
0
station:
HFA clients
S
0
station:
vCAPI clients
HG 1500 board
slot 6
Lines
HG 1500 board
slot 4
HG 1500 gate-
keeper
H.323 clients
HG 1500 board
slot 6
HG 1500 gateway
S
0
station
System clients
S
0
station:
HFA clients
System clients
Lines
System clients
V4.0 configuration V5.0 configuration

Siemens HiPath 3000 Specifications

General

Brand	Siemens
Model	HiPath 3000
Category	Telephone
Language	English