Siemens HiPath 3000 Service Manual

boards.fm
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
3-193
Boards for HiPath 3000
Peripheral Boards
Connecting ISDN (S
0
) interfaces (not for U.S.)
You can use the MW jacks on the STLS boards to connect between one and four ISDN S
0
bus-
es. The interfaces on the STLS boards are freely configurable.
● EURO CO point-to-point
● EURO CO point-to-multipoint
● EURO bus
● CorNet N/CorNet NQ slave
● Using HiPath 3000 Manager E, you can also set up configurations for networking and ded-
icated lines
Use the S
0
interface S
0
1 for connection to the public telecommunications network (ISDN trunk).
You can also connect S
0
interfaces S
0
2 to S
0
4 to the ISDN trunk or to ISDN terminals (ISDN
telephone, group 4 fax device, PC, dialing aid) via an S
0
bus.
The connection (networking) to HiPath 3000 and HiPath 4000 (CorNet NQ) can also be set up
via S
0
interfaces S
0
1 to S
0
4.
S
0
connection options:
● Point-to-point (PP) (default)
● Point-to-multipoint (PMP)
Connecting an ISDN trunk (not for U.S.)
Insert the connection cable supplied in jacks S
0
1 to S
0
4. Insert the other end in the NT of the
carrier.
Networking connection (HiPath 4000/CorNet NQ (not for U.S.)
Insert the connection cable supplied in jacks S
0
1 to S
0
4. Connect the other end with the HiPath
4000 port.

Siemens HiPath 3000 Specifications

General

Brand	Siemens
Model	HiPath 3000
Category	Telephone
Language	English