inst_h3.fm
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
4-3
Installing HiPath 3000
Installing HiPath 3800
4.2 Installing HiPath 3800
4.2.1 Installation Prerequisites
Tools and resources needed
The following are needed for installing the HiPath 3800 system:
● Tools:
– Hex or open-end wrench, 8 mm, open-end wrench 13 mm
– Diagonal cutting pliers, telephone pliers, wire stripper, flat-nosed pliers
– Slotted screwdrivers, from 2 to 8 mm (1/4 to 5/16 in.)
– Phillips or cross-point screwdrivers, sizes 1 and 2
–TORX screwdriver
– Wire stripper (for example, from Krone)
– Board wrench (part no. C39300-A7194-B10)
– Electric drill, hammer
– Level, tape measure
– For U.S. only: Punch-down tool suitable for the block used (such as block 66)
● Resources:
– Assistant T or HiPath 3000 Manager E
– Digital multimeter for testing ground connections and partial voltages
– Telephone test set for analog interfaces
– Not for U.S.: ISDN tester (such as K3000 or Aurora)
– For U.S. only: Aurora
Duet
, Aurora
Expert,
Aurora
Remote
or similar, ISDN protocol analyzer
7
Warning
Only authorized service personnel should install and start up the system.
To Next Page
Loading...
Need help?
General