start_h3.fm
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
5-17
Starting Up HiPath 3000
Starting Up HiPath 3750 and HiPath 3700
5.3.5 Not for U.S.: Entering the System Number
Introduction
Corresponding to the configuration, the system station number must be entered (without the
DID number or attendant code) on the system telephone that is assigned 100 as its internal
station number.
The system station number is determined by the network or service provider.
Depending on the configuration type, system station numbers should not be entered for
point-to-multipoint operation or for tie trunks to HiPath 4000, for example.
Example
Port number: 98008
National number: 2302 (prefix without 0)
International number: 49 (country code)
Station number type: international
Input procedure
Table 5-8 Entering the System Number
Step Entry Description
1. *95 System administration code
2. Service User name (identification)
3. XXXXX Enter password
4. Watch the display.
Scroll until “ISDN parameters” and “PABX number” appear.
Confirm your selection.
OR:
Expert mode: Enter the code 20 2 1 to 4.
5. Follow the user prompting on the display.
To Next Page
Loading...
Need help?
General