Siemens SINAMICS G120X - Replacing the Current Sensor

10.2.4.3 Replacing the current sensor
Precondition
The converter power supply is switched off.
Required tools
Torque wrench for the following screws:
● TX-20
● TX-25
● TX-30
Function description
Removing the current sensor
1. Remove screws (TX-25) of the upper and lower terminal cover:
– FSH: 3 screws
– FSJ: 4 screws
7;
1P
7;
7;
2. Remove the terminal covers.
Corrective maintenance
10.2 Replacing spare parts
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC 1069