Siemens SINAMICS G120X - Acknowledge Drive Object Faults; Ackn DO Faults; BICO Counterdevice; BICO Counterdevice; Drive Unit Status Word; Drv_Unit ZSW; Service Parameter; Serv Par

p3950 Service parameter / Serv par
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: C1, T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: For service personnel only.
r3974 Drive unit status word / Drv_unit ZSW
Access level: 1 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: Displays the status word for the drive unit.
Bit field: Bit Signal name 1 signal 0 signal FP
00 Software reset active Yes No -
01 Writing of parameters disabled as parameter save in
progress
Yes No -
02 Writing of parameters disabled as macro is running Yes No -
r3978 BICO CounterDevice / BICO CounterDevice
Access level: 4 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: Displays the counter reading for modified BICO interconnections on this device.
The counter is incremented by one for each modified BICO interconnection.
p3981 Acknowledge drive object faults / Ackn DO faults
Access level: 3 Calculated: - Data type: Unsigned8
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 8060
Min:
0
Max:
1
Factory setting:
0
Description: Setting to acknowledge all active faults of a drive object.
NOTICE
Safety messages cannot be acknowledged using this parameter.
Note
Parameter should be set from 0 to 1 to acknowledge.
After acknowledgment, the parameter is automatically reset to 0.
Parameters
7.2 Parameter list
SINAMICS G120X converter
850 Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC