Siemens SINAMICS G120X - Technological Unit Reference Quantity; Tech Unit Ref Qty

13: kg/min
14: kg/h
15: t/min
16: t/h
17: N
18: kN
19: Nm
20: psi
21: °F
22: gallon/s
23: inch³/s
24: gallon/min
25: inch³/min
26: gallon/h
27: inch³/h
28: lb/s
29: lb/min
30: lb/h
31: lbf
32: lbf ft
33: K
34: rpm
35: parts/min
36: m/s
37: ft³/s
38: ft³/min
39: BTU/min
40: BTU/h
41: mbar
42: inch wg
43: ft wg
44: m wg
45: % r.h.
46: g/kg
47: ppm
48: kg/cm²
Dependency: Only the unit of the technology controller parameters are switched over (unit group 9_1).
See also: p0596
Note
When switching over from % into another unit, the following sequence applies:
- set p0596
- set p0595 to the required unit
p0596 Technological unit reference quantity / Tech unit ref qty
Access level: 1 Calculated: - Data type: FloatingPoint32
Can be changed: T Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
0.01
Max:
340.28235E36
Factory setting:
1.00
Parameters
7.2 Parameter list
SINAMICS G120X converter
546 Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC