Siemens SINAMICS G120X - Cables

7UDQVIRUPHU
0RXQWLQJSODWH
)RXQGDWLRQ
)RXQGDWLRQ
(TXLSRWHQWLDOERQGLQJ
)XVHVVZLWFKHVDQG
FRQWDFWRUV
/LQHILOWHU
,QYHUWHU
2XWSXWUHDFWRURU
VLQHZDYHILOWHU
&RQWUROFDELQHW&RQWUROFDELQHW
'ULYHQPDFKLQH
6KLHOGVXSSRUW
(OHFWULFDOO\
FRQGXFWLYH
FRQQHFWLRQV
WKURXJKDODUJH
VXUIDFHDUHD
3(
3(3(
3(
/
1
/
/
Figure 3-3 Grounding and high-frequency equipotential bonding measures in the control cabinet and
in the plant/system
Further information
Additional information about EMC-compliant installation is available in the Internet:
EMC installation guideline (http://support.automation.siemens.com/WW/view/en/
60612658)
3.2.2 Cables
Cables with a high level of interference and cables with a low level of interference are
connected to the converter:
● Cables with a high level of interference:
– Cable between the line filter and converter
– Motor cable
– Cable at the converter DC link connection
● Cables with a low level of interference:
– Cable between the line and line filter
– Signal and data cables
Mounting
3.2 EMC-compliant setup of the machine or plant
SINAMICS G120X converter
54 Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC