Siemens SINAMICS G120X - Hibernation Mode Using Technology Setpoint as Main Setpoint with Boost; Interaction of the Function with the Cascade Control

To avoid tank deposits, particularly where liquids are involved, it is possible to exit the
hibernation mode after an adjustable time (p2396) has expired and switch to normal operation.
The settings required for the respective variant can be found in the following tables.
Interaction of the function with the cascade control
It is not possible to activate the hibernation mode as long as a motor is directly operated from
the line supply using the cascade control function.
Cascade control (Page 368)
Activating the hibernation mode with setpoint input via the internal technology controller
With this operating mode you have to set the technology controller as the setpoint source
(p2200) and use the output of the technology controller as the main setpoint (p2251). The boost
can be deactivated.
1RUPDORSHUDWLRQ1RUPDORSHUDWLRQ
6HWSRLQWWHFKQRORJ\FRQWUROOHUDV
PDLQVHWSRLQW
+LEHUQDWLRQ
PRGHRIIVHW
7HFKQRORJ\FRQWUROOHUGHYLDWLRQ
U
5HVWDUWVSHHG
%RRVWVSHHGS
6WDUWVSHHG
+LEHUQDWLRQPRGHDFWLYH
UHVWDUWVSHHG
0LQLPXPVSHHGS
5HVWDUWYDOXHS
5HVWDUWVSHHG
6WDUWVSHHG
6SHHG
SSyS
SSy
W
[

W
\

SS಺
SS
S


W
W
S
W
\
W
[
SS
Figure 6-101 Hibernation mode using the technology setpoint as main setpoint with boost
Advanced commissioning
6.10 Energy saving
SINAMICS G120X converter
446 Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC