p2107[0...n] BI: External fault 2 / External fault 2
Access level: 3 Calculated: - Data type: Unsigned32 / Binary
Can be changed: T, U Scaling: - Dynamic index: CDS, p0170
Unit group: - Unit selection: - Function diagram: 2546
Min:
-
Max:
-
Factory setting:
1
Description: Sets the signal source for external fault 2.
Dependency: See also: F07861
Note
An external fault is triggered with a 1/0 signal.
p2108[0...n] BI: External fault 3 / External fault 3
Access level: 3 Calculated: - Data type: Unsigned32 / Binary
Can be changed: T, U Scaling: - Dynamic index: CDS, p0170
Unit group: - Unit selection: - Function diagram: 2546
Min:
-
Max:
-
Factory setting:
1
Description: Sets the signal source for external fault 3.
External fault 3 is initiated by the following AND logic operation:
- BI: p2108 negated
- BI: p3111
- BI: p3112 negated
Dependency: See also: p3110, p3111, p3112
See also: F07862
Note
An external fault is triggered with a 1/0 signal.
p2108[0...n] BI: External fault 3 / External fault 3
G120X_DP (PM330),
G120X_PN (PM330),
G120X_USS (PM330)
Access level: 3 Calculated: - Data type: Unsigned32 / Binary
Can be changed: T, U Scaling: - Dynamic index: CDS, p0170
Unit group: - Unit selection: - Function diagram: 2546
Min:
-
Max:
-
Factory setting:
4022.1
Description: Sets the signal source for external fault 3.
External fault 3 is initiated by the following AND logic operation:
- BI: p2108 negated
- BI: p3111
- BI: p3112 negated
Dependency: See also: p3110, p3111, p3112
See also: F07862
Note
An external fault is triggered with a 1/0 signal.
r2109[0...63] Fault time removed in milliseconds / t_flt resolved ms
Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 8050, 8060
Min:
- [ms]
Max:
- [ms]
Factory setting:
- [ms]
Parameters
7.2 Parameter list
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC 767
To Next Page
Loading...
