Siemens SINAMICS G120X - PN Default Gateway Actual; PN Def Gateway Act; PN IP Address Actual; PN IP Addr Act; PN Name of Station Actual; PN Name Stat Act; PN Subnet Mask Actual; PN Subnet Mask Act

r8930[0...239] PN Name of Station actual / PN Name Stat act
G120X_PN Access level: 3 Calculated: - Data type: Unsigned8
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: Displays the actual station name for the onboard PROFINET interface on the Control Unit.
r8931[0...3] PN IP address actual / PN IP addr act
G120X_PN Access level: 3 Calculated: - Data type: Unsigned8
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
0
Max:
255
Factory setting:
-
Description: Displays the actual IP address for the onboard PROFINET interface on the Control Unit.
r8932[0...3] PN Default Gateway actual / PN Def Gateway act
G120X_PN Access level: 3 Calculated: - Data type: Unsigned8
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
0
Max:
255
Factory setting:
-
Description: Displays the actual default gateway for the onboard PROFINET interface on the Control Unit.
r8933[0...3] PN Subnet Mask actual / PN Subnet Mask act
G120X_PN Access level: 3 Calculated: - Data type: Unsigned8
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
0
Max:
255
Factory setting:
-
Description: Displays the actual subnet mask for the onboard PROFINET interface on the Control Unit.
r8934 PN DHCP Mode actual / PN DHCP Mode act
G120X_PN Access level: 3 Calculated: - Data type: Integer16
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
0
Max:
3
Factory setting:
-
Description: Displays the actual DHCP mode for the onboard PROFINET interface on the Control Unit.
Value: 0: DHCP off
2: DHCP on, identification using MAC address
3: DHCP on, identification via name of station
NOTICE
When the DHCP mode is active (parameter value not equal to 0), PROFINET communication via this interface is no
longer possible!
Parameters
7.2 Parameter list
SINAMICS G120X converter
884 Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC