3.4.3 Mounting the shield connection kits
Overview
We recommend that you mount the shield connection kits provided. The shield connection kit
makes it simpler to install the converter in compliance with EMC regulations and to provide
strength relief for the connected cables.
Mounting the shield connection kit for the Control Unit
Note
The shield connection kit for the Control Unit is available for converters FSD to FSG only.
Attach the shielding plate to the bottom of the Control Unit, and use a cross-tip screwdriver PZ
to tighten the screw to fix it onto the converter.
Mounting the shield connection kit for the Power Module, FSA ... FSC
Procedure
1. Remove the two screws and two U clamps from the bottom of the converter ①.
2. Mount the two U clamps with the two screws on the shield plate ②.
3. Fasten the shield plate in place using two screws ③.
Mounting
3.4 Mounting the converter
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC 67
To Next Page
Loading...
