Siemens SINAMICS G120X - CI: Free Tec_Ctrl 1 Limit Maximum Signal Source; Ftec1 Lim Max S_S; CI: Free Tec_Ctrl 1 Limit Minimum Signal Source; Ftec1 Lim Min S_S; CI: Free Tec_Ctrl 1 Limit Offset Signal Source; Ftec1 Lim Offs; CO: Free Tec_Ctrl 1 Output Signal; Ftec1 Out_Sig

r11194 CO: Free tec_ctrl 1 output signal / Ftec1 out_sig
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: - Scaling: PERCENT Dynamic index: -
Unit group: - Unit selection: - Function diagram: 7030
Min:
- [%]
Max:
- [%]
Factory setting:
- [%]
Description: Display and connector output for the output signal of the free technology controller 1.
p11197 CI: Free tec_ctrl 1 limit maximum signal source / Ftec1 lim max s_s
Access level: 3 Calculated: - Data type: Unsigned32 /
FloatingPoint32
Can be changed: T, U Scaling: PERCENT Dynamic index: -
Unit group: - Unit selection: - Function diagram: 7030
Min:
-
Max:
-
Factory setting:
11191[0]
Description: Sets the signal source for the maximum limit of the free technology controller 1.
Dependency: See also: p11191
p11198 CI: Free tec_ctrl 1 limit minimum signal source / Ftec1 lim min s_s
Access level: 3 Calculated: - Data type: Unsigned32 /
FloatingPoint32
Can be changed: T, U Scaling: PERCENT Dynamic index: -
Unit group: - Unit selection: - Function diagram: 7030
Min:
-
Max:
-
Factory setting:
11192[0]
Description: Sets the signal source for the minimum limit of the free technology controller 1.
Dependency: See also: p11192
p11199 CI: Free tec_ctrl 1 limit offset signal source / Ftec1 lim offs
Access level: 3 Calculated: - Data type: Unsigned32 /
FloatingPoint32
Can be changed: T, U Scaling: PERCENT Dynamic index: -
Unit group: - Unit selection: - Function diagram: 7030
Min:
-
Max:
-
Factory setting:
0
Description: Sets the signal source for the limit offset of the free technology controller 1.
p11200 BI: Free tec_ctrl 2 enable / Ftec2 enab
Access level: 2 Calculated: - Data type: Unsigned32 / Binary
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 7030
Min:
-
Max:
-
Factory setting:
0
Description: Sets the signal source to switch in/switch out the free technology controller 2.
1 signal: The technology controller is switched in.
0 signal: The technology controller is switched out.
Parameters
7.2 Parameter list
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC 907