Table 2-1 IP21 top cover dimensions - mm (inch)
Frame size Clearance A B C D Ø Tightening
torque
FSA 100 (3.9) 25 (1.0) 120 (4.7) 80 (3.15) 306 (12.0) 4.5 (0.18) 3 Nm
(27 lbf.in)
FSB 160 (6.3) 118 (4.6) 5.5 (0.22)
FSC 29 (1.1) 260 (10.2) 170 (6.7) 323 (12.7) 6.0 (0.24) 6 Nm
(53 lbf.in)
FSD 300 (11.8)
FSE 335 (13.2) 230 (9.1)
FSF, FSG 365 (14.4) 270 (10.6) 443 (17.4)
Article number
Converter frame size Article number
FSA 6SL3266-1PA00-0BA0
FSB 6SL3266-1PB00-0BA0
FSC, FSD 6SL3266-1PD00-0BA0
FSE 6SL3266-1PE00-0BA0
FSF, FSG 6SL3266-1PF00-0BA0
FSH, FSJ Not available
2.6.10 Mounting kit for line-side cable connection, left (FSH only)
Alternatively, for converters of frame size FSH, the line supply cables can be connected on the
left side of the converter using this optional mounting kit. The converter can then be installed
higher in the control cabinet, allowing more efficient use of the available cabinet space. In many
cases, use of this installation kit also helps in the implementation of effective cabinet cooling.
For converters of frame size FSJ, the line supply cables can only be connected from the top.
Article number: 6SL3366-1LH00-0PA0
2.6.11 I/O Extension Module
The SINAMICS G120X I/O Extension Module is available as an optional component. It expands
the number of the I/O terminals on the converter, enabling more converter control functions. It
also provides connection to the operator panel or SINAMICS G120 Smart Access.
Article number: 6SL3255-0BE00-0AA0
Note
The SINAMICS G120X I/O Extension Module is only supported on the G120X converter with
FS version 02 02 (FSA ... FSG)/02 (FSH/FSJ) or higher.
Description
2.6 Optional components
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC 45
To Next Page
Loading...
