04 Start ramp-function generator Yes No -
05 Wait for execution Yes No -
06 Slope filter act Yes No -
07 Positive gradient Yes No -
08 Current < threshold Yes No -
09 Current minimum Yes No -
10 Search in the positive direction Yes No -
11 Stop after positive direction Yes No -
12 Stop after negative direction Yes No -
13 No result Yes No -
14 Fast flying restart w/ voltage model for induction motor activ. Yes No -
15 Flying restart with VSM active Yes No -
r1205.0...21 CO/BO: Flying restart vector control status / FlyRest vector st
Access level: 4 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: Display and connector output for the status for checking and monitoring flying restart states in the vector control mode.
Bit field: Bit Signal name 1 signal 0 signal FP
00 Speed adaptation circuit record angle Yes No -
01 Speed adaptation circuit set gain to 0 Yes No -
02 Isd channel enable Yes No -
03 Speed control switched out Yes No -
04 Quadrature arm switched in Yes No -
05 Special transformation active Yes No -
06 Speed adaptation circuit set I component to 0 Yes No -
07 Current control on Yes No -
08 Isd_set = 0 A Yes No -
09 Frequency held Yes No -
10 Search in the positive direction Yes No -
11 Search Started Yes No -
12 Current impressed Yes No -
13 Search interrupted Yes No -
14 Speed adaptation circuit deviation = 0 Yes No -
15 Speed control activated Yes No -
16 Fast flying restart w/ voltage model for induction motor activ. Yes No -
17 Fast flying restart w/ voltage model for induction motor exited Yes No -
18 Apply VSM voltage to the monitor Yes No -
19 Preassign flux ramp Yes No -
20 Adaptation current controller and speed adapt. controller gain Yes No -
21 Voltage pulse active Yes No -
Note
For bit 00 ... 09:
Used to control internal sequences during the flying restart.
Depending on the motor type (p0300), the number of active bits differs.
For bits 10 ... 15:
Are used to monitor the flying restart sequence.
Parameters
7.2 Parameter list
SINAMICS G120X converter
646 Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
To Next Page
Loading...
