p5611 Pe energy-saving properties general / Pe properties gen
G120X_PN Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: T Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 2381, 2382
Min:
-
Max:
-
Factory setting:
0000 bin
Description: Sets the general properties for energy-saving.
Bit field: Bit Signal name 1 signal 0 signal FP
00 Inhibit PROFIenergy control commands Yes No -
01 Drive initiates OFF1 when transitioning to energy-saving
mode
Yes No -
02 Trans to energy-saving mode from PROFIdrive state S3/4
poss
Yes No -
Note
Pe: PROFIenergy profiles
PROFIdrive state S4: operation
p5612[0...1] Pe energy-saving properties mode-dependent / Pe properties mod
G120X_PN Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: T Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
[0] 0110 bin
[1] 0000 bin
Description: Sets the mode-dependent properties for energy-saving.
Index: [0] = Reserved
[1] = Mode 2
Bit field: Bit Signal name 1 signal 0 signal FP
00 Reserved Yes No -
Note
Pe: PROFIenergy profiles
r5613.0...1 CO/BO: Pe energy-saving active/inactive / Pe save act/inact
G120X_PN Access level: 3 Calculated: - Data type: Unsigned8
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 2382
Min:
-
Max:
-
Factory setting:
-
Description: Display and binector output for the state display PROFIenergy energy saving active or inactive.
Bit field: Bit Signal name 1 signal 0 signal FP
00 Pe active Yes No -
01 Pe inactive Yes No -
Note
Bit 0 and bit 1 are inverse of one another.
Pe: PROFIenergy profiles
Parameters
7.2 Parameter list
SINAMICS G120X converter
858 Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
To Next Page
Loading...
