Siemens SINAMICS G120X - Error Values and Measured Values; Status Queries

6.10.8.2 Status queries
Function description
Command Explanation
List_Energy_Saving_Modes Returns all supported energy-saving modes
Get_Mode Returns information about the selected energy-saving mode
PEM_Status Returns the current PROFIenergy status
PEM_Status_with_CTTO Returns the current PROFIenergy status together with the regular
transition time to the operating state
PE_ldentify Returns the supported PROFIenergy commands
Query_Version Returns the implemented PROFIenergy profile
Get_Measurement_List Returns the measured value IDs that can be accessed using the
"Get_Measurement_Values" command
Get_Measure‐
ment_List_with_object_number
Returns the measured value IDs and the associated object number
that can be accessed using the "Get_Measurement_Values_with_ob‐
ject_number" command.
Get_Measurement_Values Returns the measured values requested via the measured value ID
Get_Measurement_Val‐
ues_with_object_number
Returns the measured values requested via the measured value ID
and the object number. The object number corresponds to the drive
object ID.
6.10.8.3 Error values and measured values
Function description
Table 6-110 Error values in the parameter response
Error val‐
ue 1
Meaning
001 hex Invalid Service_Request_ID
03 hex Invalid Modifier
04 hex Invalid Data_Structure_Identifier_RQ
06 hex No PE energy-saving mode supported
07 hex Response too long
08 hex Invalid block header
50 hex No suitable energy-saving mode available
51 hex Time is not supported
52 hex Impermissible PE_Mode_ID
53 hex No switch to energy saving mode because of state operate
54 hex Service or function temporarily not available
Advanced commissioning
6.10 Energy saving
SINAMICS G120X converter
458 Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC