00 DI 0 (X133. 5) Simulation Terminal eval -
01 DI 1 (X133. 6) Simulation Terminal eval -
02 DI 2 (X133. 7) Simulation Terminal eval -
03 DI 3 (X133. 8) Simulation Terminal eval -
04 DI 4 (X133. 16) Simulation Terminal eval -
05 DI 5 (X133. 17) Simulation Terminal eval -
06 DI 6 (X203. 88) Simulation Terminal eval -
07 DI 7 (X203. 87) Simulation Terminal eval -
11 DI 11 (X132. 3, 4) AI 0 Simulation Terminal eval -
12 DI 12 (X132.10, 11) AI 1 Simulation Terminal eval -
Dependency: The setpoint for the input signals is specified using p0796.
See also: p0796
Note
This parameter is not saved when data is backed up (p0971).
AI: Analog Input
DI: Digital Input
X203: IO module terminal
p0796 CU digital inputs simulation mode setpoint / CU DI simul setp
Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 2201, 2221,
2256
Min:
-
Max:
-
Factory setting:
0000 0000 0000 0000 bin
Description: Sets the setpoint for the input signals in the digital input simulation mode.
Bit field: Bit Signal name 1 signal 0 signal FP
00 DI 0 (X133. 5) High Low -
01 DI 1 (X133. 6) High Low -
02 DI 2 (X133. 7) High Low -
03 DI 3 (X133. 8) High Low -
04 DI 4 (X133. 16) High Low -
05 DI 5 (X133. 17) High Low -
06 DI 6 (X203. 88) High Low -
07 DI 7 (X203. 87) High Low -
11 DI 11 (X132.3, 4) AI 0 High Low -
12 DI 12 (X132. 10, 11) AI 1 High Low -
Dependency: The simulation of a digital input is selected using p0795.
See also: p0795
Note
This parameter is not saved when data is backed up (p0971).
AI: Analog Input
DI: Digital Input
X203: IO module terminal
Parameters
7.2 Parameter list
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC 577
To Next Page
Loading...
