Settings:
● Analog output AO and analog input AI:
p0776[0] = 0: AO is current output 0 mA … 20 mA, corresponding to the factory setting 0 %
… 100 %
p0756[x] = 0: AI x is voltage input 0 V … 10 V, corresponding to the factory setting 0 % …
100 %. Also set the associated switch on the converter to "U".
p29701 = r0755[x]. x is the number of the analog input where the Pt100 is connected.
p771[0] = r29706.
● Temperature monitoring: The converter evaluates the motor temperature in the range from
-48 °C ... +248 °C.
– Number of Pt100 connected in series: p29700
– Overtemperature alarm (A07910):
- motor temperature > p0604 and p0610 = 0
– Overtemperature fault (F07011):
The converter responds with a fault in the following cases:
- motor temperature > p0605
- motor temperature > p0604 and p0610 > 0
● The converter does not monitor the sensor.
Parameters
Table 6-102 General parameters
Number Name Factory setting
p0335[M] Type of motor cooling 0
p0601[M] Motor temperature sensor type 0
p0604[M] Mot_temp_mod 2/sensor alarm threshold 130 °C
p0605[M] Mot_temp_mod 1/2/sensor threshold and temperature value 145 °C
p0610[M] Motor overtemperature response 12
p0640[D] Current limit 0 Arms
Table 6-103 Additional parameters for Pt100
Number Name Factory setting
p29700[D] Temperature sensor type 0
p29701 CI: Temperature sensor voltage source 0
p29704 Cable resistance 0 Ω
r29705 CO: actual temperature sensor value [°C]
r29706 CO: temperature sensor excitation current [%]
r29707 CO: temperature sensor resistance value [Ω]
p29708 Set temperature sensor excitation current 50 %
Advanced commissioning
6.8 Drive protection
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC 411
To Next Page
Loading...
