Siemens SINAMICS G120X - Advanced Settings

The principle of operation of the other parameters is explained in the following diagram and in
the table below.
,IVWDUWDWWHPSWFRXQWHUWKHQIDXOW
)LVRXWSXW
)DXOWDIWHUSRZHUIDLOXUHRU
LQRSHUDWLRQ
VWVWDUWDWWHPSW
XQVXFFHVVIXOGXH
WRDQHZIDXOW
$VWDUWDWWHPSWPXVWKDYHEHHQVXFFHVVIXOZLWKLQ
S>@,IQRWWKHQIDXOW)LVRXWSXW
$IWHUS>@WKHLQYHUWHUUHVHWV
WKHVWDUWDWWHPSWFRXQWHU
QGVWDUWDWWHPSWLV
VXFFHVVIXO

&RXQWHUVWDUWDWWHPSWV
$XWRPDWLFDFNQRZOHGJPHQW

$XWRPDWLF21FRPPDQG

6SHHG
W
:
 VXPRIWKHWLPHVIRUDIO\LQJ
UHVWDUWDQGPDJQHWL]LQJWKH
PRWRU
W
W
W
W
W
S
S
S
V
V
SS
W
:
W
:
1)
The converter automatically acknowledges faults under the following conditions:
● p1210 = 1 or 26: Always.
● p1210 = 4 or 6: If the command to switch-on the motor is available at a digital input or via the
fieldbus (ON/OFF1 = 1).
● p1210 = 14 or 16: Never.
2)
The converter attempts to automatically switch the motor on under the following conditions:
● p1210 = 1: Never.
● p1210 = 4, 6, 14, 16, or 26: If the command to switch-on the motor is available at a digital input or
via the fieldbus (ON/OFF1 = 1).
3)
If, after a flying restart and magnetization (r0056.4 = 1) no fault occurs within one second, then the
start attempt was successful.
Figure 6-89 Time response of the automatic restart
Further information is provided in the parameter list.
Advanced settings
If you with to suppress the automatic restart function for certain faults, then you must enter the
appropriate fault numbers in p1206[0 … 9].
Example: p1206[0] = 07331 ⇒ No restart for fault F07331.
Advanced commissioning
6.9 Drive availability
SINAMICS G120X converter
426 Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC