Siemens SINAMICS G120X - Minimum and Maximum Speed; Operate the Motor in the Factory Setting; Jogging the Motor in the Factory Setting

0RWRUVSHHG
&RXQWHUFORFNZLVHLVLQKLELWHG
-RJ
USP
-RJ
W
W
W
Figure 5-5 Jogging the motor in the factory setting
Minimum and maximum speed
● Minimum speed - factory setting 0 [rpm]
After the selection of a motor, during the quick commissioning, the converter sets the
minimum speed to 20% of the rated speed.
The minimum speed is the lowest speed of the motor independent of the speed setpoint.
● Maximum speed - factory setting 1500 [rpm]
The converter limits the motor speed to this value.
Operate the motor in the factory setting
We recommend that you execute quick commissioning. For quick commissioning, you must
adapt the converter to the connected motor by setting the motor data in the converter.
For basic applications, you can try to operate the drive with a rated power < 18.5 kW without any
other commissioning steps. Check whether the control quality of the drive without
commissioning is adequate for the requirements of the application.
Commissioning
5.3 Preparing for commissioning
SINAMICS G120X converter
158 Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC