Note
Changes only become effective after POWER ON.
The parameter is not influenced by setting the factory setting.
p2031 Fieldbus interface MODBUS parity / Modbus parity
G120X_USS Access level: 2 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 9310
Min:
0
Max:
2
Factory setting:
2
Description: Sets the parity for the Modbus protocol (p2030 = 2).
Value: 0: No parity
1: Odd parity
2: Even parity
Note
Fieldbus IF: Fieldbus interface
Changes only become effective after POWER ON.
The parameter is not influenced by setting the factory setting.
The parameter is set to the factory setting when the protocol is reselected (p2030 = 2).
r2032 Master control control word effective / PcCtrl STW eff
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: Displays the effective control word 1 (STW1) of the drive for the master control.
Bit field: Bit Signal name 1 signal 0 signal FP
00 ON/OFF1 Yes No -
01 OC / OFF2 Yes No -
02 OC / OFF3 Yes No -
03 Enable operation Yes No -
04 Enable ramp-function generator Yes No -
05 Start ramp-function generator Yes No -
06 Enable speed setpoint Yes No -
07 Acknowledge fault Yes No -
08 Jog bit 0 Yes No 3030
09 Jog bit 1 Yes No 3030
10 Master control by PLC Yes No -
NOTICE
The master control only influences control word 1 and speed setpoint 1. Other control word/setpoints can be
transferred from another automation device.
Note
OC: Operating condition
Parameters
7.2 Parameter list
SINAMICS G120X converter
742 Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
To Next Page
Loading...
