Siemens SINAMICS G120X - Link Object, Instance Number: F6 Hex

No. Service Type Name Value/explanation
3 get, set UNIT32 Configuration
Control
1 hex: Saved values
3 hex: DHCP
4 get UNIT16 Path Size (in
WORDs)
Fixed value: 2 hex
UNIT8 Path 20 hex,
F6 hex,
24 hex,
05 hex, where 5 hex is the number of instances of F6
hex (four physical ports plus one internal port).
5 get, set STRING Interface Configu‐
ration
r61000 Name of Station
UNIT32 r61001 IP address
6 get, set UNIT16 Host Name Host Name Length
STRING
10 get, set UNIT8 Select ACD local OM flash:
0: Disabled,
1: Enabled
11 get, set UNIT8 Last Conflict De‐
tected
local OM flash ACD Activity
UNIT8 local OM flash Remote MAC
UNIT8 local OM flash ARP PDU
Link Object, Instance Number: F6 hex
Supported services
Class ● Get Attribute all
● Get Attribute single
Instance ● Get Attribute all
● Get Attribute single
● Set Attribute single
Table 6-38 Class Attribute
No. Service Type Name
1 get UINT16 Revision
2 get UINT16 Max Instance
3 get UINT16 Num of Instances
Table 6-39 Instance Attribute
No. Service Type Name Value/explanation
1 get UINT32 Interface Speed 0: link down,
10: 10 Mbps,
100: 100 Mbps
2 get Interface Flags Bit 1: Link-Status
Bit 2: Duplex Mode (0: halb duplex, 1 duplex
Bit 3 … 5: Automatic state identification
Bit 6: Reset required
Bit 7: Local hardware fault (0 = ok)
Advanced commissioning
6.3 Drive control
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC 237