Siemens SINAMICS G120X - Profienergy

Parameters
Number Name Factory setting
p29631[0...4] Flow meter pump power 0.00 kW
p29632[0...4] Flow meter pump flow 0.00 m
3
/h
r29633 Flow meter calculated flow - m
3
/h
For more information about the parameters, see Chapter "Parameter list (Page 470)".
6.10.8 PROFIenergy
Overview
PROFIenergy is a standard based on PROFINET. PROFIenergy is certified and described in
the PROFIenergy profile of the PNO.
The higher-level controller transfers the control commands and status queries in acyclic
operation via data record 80A0 hex.
The converter supports the PROFIenergy profile V1.1 and the function unit class 3.
The converter supports PROFIenergy energy-saving mode 2.
Function description
Behavior of the converter with active energy-saving mode 2:
● The converter outputs alarm A08800.
● The RDY LED flashes green: 500 ms on, 3000 ms off.
● The converter does not send any diagnostic interrupts.
● If the higher-level controller goes to stop or the bus connection to the higher-level controller
is interrupted, the converter exits the energy-saving mode and resumes normal operation.
Example
You can find an application example for PROFIenergy on the Internet:
PROFIenergy - saving energy with SIMATIC S7 (https://
support.industry.siemens.com/cs/ww/en/view/41986454)
Parameters
Number Name Factory setting
r5600 Pe energy-saving mode ID -
r5613 CO/BO: Pe energy-saving active/inactive -
Advanced commissioning
6.10 Energy saving
SINAMICS G120X converter
456 Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC