Siemens SINAMICS G120X - Identification and Maintenance 1; I&M 1; Identification and Maintenance 4 Configuration; I&M 4 Config; Macro Connector Inputs (CI) for Torque Setpoints; Macro CI M_Set; Macro Execution Actual; Macro Executed

r8573[0...39] Macro Connector Inputs (CI) for torque setpoints / Macro CI M_set
Access level: 4 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: Displays the ACX file saved in the appropriate directory in the non-volatile memory.
Note
For a value = 9999999, the following applies: The read operation is still running.
r8585 Macro execution actual / Macro executed
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: Displays the macro currently being executed on the drive object.
Dependency: See also: p0015, p1000, r8570, r8571, r8572, r8573
p8805 Identification and maintenance 4 configuration / I&M 4 config
G120X_PN Access level: 3 Calculated: - Data type: Integer16
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
0
Max:
1
Factory setting:
0
Description: Sets the configuration for the content of identification and maintenance 4 (I&M 4, p8809).
Value: 0: Standard value for I&M 4 (p8809)
1: User value for I&M 4 (p8809)
Dependency: For p8805 = 0, if the user writes at least one value in p8809[0...53], then p8805 is automatically set to = 1.
When p8805 is reset = 0, then the content of the factory setting is set in p8809.
Note
For p8805 = 0:
PROFINET I&M 4 (p8809) contains the information for the SI change tracking.
For p8805 = 1:
PROFINET I&M 4 (p8809) contains the values written by the user.
p8806[0...53] Identification and Maintenance 1 / I&M 1
G120X_PN Access level: 3 Calculated: - Data type: Unsigned8
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
Description: Parameters for the PROFINET data set "Identification and Maintenance 1" (I&M 1).
This information is known as "System identifier" and "Location identifier".
Dependency: See also: p8807, p8808
NOTICE
Only characters belonging to the standard ASCII character set may be used (32 dec to 126 dec).
Parameters
7.2 Parameter list
SINAMICS G120X converter
878 Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC