Siemens SINAMICS G120X - BO: STW1 from IOP in the Manual Mode; STW1 IOP; CO: Speed Setpoint from the IOP in the Manual Mode; N_Set IOP

r8540.0...15 BO: STW1 from IOP in the manual mode / STW1 IOP
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: For the manual mode: the STW1 (control word 1) entered from the IOP is displayed.
Bit field: Bit Signal name 1 signal 0 signal FP
00 ON/OFF1 Yes No -
01 OC / OFF2 Yes No -
02 OC / OFF3 Yes No -
03 Reserved Yes No -
04 Reserved Yes No -
05 Reserved Yes No -
06 Reserved Yes No -
07 Acknowledge fault Yes No -
08 Jog bit 0 Yes No 3030
09 Jog bit 1 Yes No 3030
10 Reserved Yes No -
11 Direction reversal (setpoint) Yes No -
12 Reserved Yes No -
13 Reserved Yes No -
14 Reserved Yes No -
15 Reserved Yes No -
r8541 CO: Speed setpoint from the IOP in the manual mode / n_set IOP
Access level: 3 Calculated: - Data type: FloatingPoint32
Can be changed: - Scaling: p2000 Dynamic index: -
Unit group: 3_1 Unit selection: p0505 Function diagram: -
Min:
- [rpm]
Max:
- [rpm]
Factory setting:
- [rpm]
Description: For the manual mode: the speed setpoint entered from the IOP is displayed.
Parameters
7.2 Parameter list
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC 875