2.6.7 Push-through mounting kit
Overview
The optional push-through mounting kit is used to mount a converter in a control cabinet with
its heatsink passing through the cabinet panel. The push-through mounted converters can fulfill
a degree of protection of IP20 (UL Open Type). The back side of the converter must be
enclosed adequately.
Note
Push-through mounting kits are available for converters of frame sizes FSA to FSG only.
WARNING
Spread of fire from the back side of the converter
Component failures can cause spread of fire and smoke from the back side of a converter
installed with a push-through mounting kit. This can result in serious personal injury or
property damage.
● Cover the back side of the converter sufficiently with a metallic cover or a separate metallic
air duct or similar.
Article number
Converter frame size Article number
FSA 6SL3261-6GA00-0BA0
FSB 6SL3261-6GB00-0BA0
FSC 6SL3261-6GC00-0BA0
FSD 6SL3261-6GD00-0BA0
FSE 6SL3261-6GE00-0BA0
FSF 6SL3261-6GF00-0BA0
FSG 6SL3261-6GG00-0BA0
Mounting the converter with the push-through mounting kit
The push-through mounting kit comprises one piece of frame for converter FSA to FSC, and
four pieces of frames for converter FSD to FSG.
Mount the converter with push-through mounting kit on the uncoated panel of the control
cabinet. Further information about EMC-compliant installation is available in the following
section:
EMC-compliant setup of the machine or plant (Page 52)
Description
2.6 Optional components
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC 41
To Next Page
Loading...
