Xerox WorkCentre 3615 Service Manual

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-154
FIP 1. 70
016-931 USB Hub Error
Cause:
• Warning to installation of hub that cannot be used to USB host.
• Detect installation of hubs in more than supported number of stacks.
Solution:
1. The number of hub stages exceeds the specified value.
• Reduce the number of the hub stages.
2. If the error persists, ensure that the error is replicated after the printer is powered Off and
then On, and then replace (REP 5.1 ESS PWB).
FIP 1. 71
016-982 Disk Full
Cause:
The current printing job process cannot be continued because the RAM disk is full.
Solution:
The machine will recover after the OK button is pressed or message is displayed for specified
time.
If the error persists:
1. It is necessary to delete unnecessary data or System Settings increase the RAM Disk capacity
in System Settings.
2. After increasing the RAM Disk capacity, turn the printer Off and then On.
3. Ensure that the error is replicated after the printer is powered Off and then On, and then
divide the print job into several blocks, then execute printing on a block by block basis.
• Upgrade memory as required.
• Upgrade SD CARD as required.

Xerox WorkCentre 3615 Specifications

General

Print Technology	Laser
Print Resolution	Up to 1200 x 1200 dpi
Fax	Yes
Duplex Printing	Yes
Functions	Print, Copy, Scan, Fax
Processor	533 MHz
Memory (Standard)	256 MB
Paper Output	250 sheets
Fax Speed	33.6 kbps
Print Speed	47 ppm
Scan Resolution	600 x 600 dpi
Automatic Document Feeder	50 sheets
Connectivity	Ethernet
First Page Out Time (Copy)	8.5 seconds
Paper Capacity	250 sheets
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac, Linux