Xerox WorkCentre 3615 Service Manual

Maintenance
Phaser 3610, WorkCentre 3615 Service Manual6-8
ADJ 2 Adjusting the Transfer Unit
Adjusting the Transfer Unit can decrease a mottled appearance or white spots in your prints. This
adjustment is available for each paper type.
Note: This setting affects print quality. The higher the value, the darker the printed output
appears.
(3610) Procedure
1. At the printer control panel, press the Menu button.
Note: To navigate through the menu, use the Up or Down arrow buttons.
2. Navigate to Admin Settings, then press OK.
3. Navigate to Service Tools, then press OK.
4. Navigate to the paper type for the adjustment, then press OK.
5. To increase or decrease the bias voltage, use the arrow buttons, then press OK.
6. Repeat this procedure for each paper type you need to adjust.
7. To return to Service Tools, press the Back arrow button, or to return to the main menu, press the
Menu button.
(3615) Procedure
1. At the printer control panel, press the Machine Status button.
2. Touch Tool s, then touch Admin Settings.
3. Touch Service Tools.
4. Touch Adjust Transfer Unit.
5. Touch the paper for the adjustment, touch (-) or (+), then touch OK.
6. Repeat this procedure for each paper type you need to adjust.
7. To return to the Services Home menu, press the Services Home button.

Xerox WorkCentre 3615 Specifications

General

Print Technology	Laser
Print Resolution	Up to 1200 x 1200 dpi
Fax	Yes
Duplex Printing	Yes
Functions	Print, Copy, Scan, Fax
Processor	533 MHz
Memory (Standard)	256 MB
Paper Output	250 sheets
Fax Speed	33.6 kbps
Print Speed	47 ppm
Scan Resolution	600 x 600 dpi
Automatic Document Feeder	50 sheets
Connectivity	Ethernet
First Page Out Time (Copy)	8.5 seconds
Paper Capacity	250 sheets
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac, Linux