Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual 2-313
FIP 1. 384
134-211 Fax Card Modem Error
Cause:
Fax Card parts error. (MODEM error)
Solution:
1. Turn the power Off and On to check that the error recurs.
2. Check the telephone line connection. Reconnect the telephone line connector.
3. Check the sending side fax. Receive the fax data from a good fax machine.
4. Update to the latest F/W.
5. If the error persists, ensure that the error is replicated after the printer is powered Off and
then On, and then replace the following parts in sequence.
•(REP 5.4 Fax PWB)
•(REP 5.1 ESS PWB)
FIP 1. 385
142-700 IOT Over Heat Forced Half Speed
Cause:
Half-speed operation was forced due to abnormally high temperature inside the IOT.
Solution:
1. No action is required.
2. Start the operation after the Printer has cooled down.
FIP 1. 386
193-700 Custom Toner Mode
Cause:
The printer is in custom toner mode.
Solution:
No action is required.
To Next Page
Loading...
