Xerox WorkCentre 3615 Service Manual

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-260
FIP 1. 274
071-920 Waiting to Print Side 2 Load Printed Pages into the NNN
Cause:
Waiting for side 2 to be set for manual duplex print (Tray).
Solution:
Set the Paper correctly. Press OK button within the specified time.
FIP 1. 275
071-921 Manual Duplex Print
Cause:
Waiting for Set key to be pressed after setting side 2 for manual duplex print (Tray).
Solution:
Set the Paper correctly. Press OK button within the specified time.
FIP 1. 276
072-100 IOT Tray2 Misfeed Jam
073-100 IOT Tray3 Misfeed Jam
074-100 IOT Tray4 Misfeed Jam
Cause:
072-100:
050-139 is displayed in the UI.
After the Tray 2 Feed Clutch turned ON, the Tray 2 Path Sensor did not turn ON within the
specified time.
073-100:
050-140 is displayed in the UI.
After the Tray 3 Feed Clutch turned ON, the Tray 3 Path Sensor did not turn ON within the
specified time.
074-100:
050-141 is displayed in the UI.
After the Tray 4 Feed Clutch turned ON, the Tray 4 Path Sensor did not turn ON within the
specified time.

Xerox WorkCentre 3615 Specifications

General

Print Technology	Laser
Print Resolution	Up to 1200 x 1200 dpi
Fax	Yes
Duplex Printing	Yes
Functions	Print, Copy, Scan, Fax
Processor	533 MHz
Memory (Standard)	256 MB
Paper Output	250 sheets
Fax Speed	33.6 kbps
Print Speed	47 ppm
Scan Resolution	600 x 600 dpi
Automatic Document Feeder	50 sheets
Connectivity	Ethernet
First Page Out Time (Copy)	8.5 seconds
Paper Capacity	250 sheets
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac, Linux