Overview
Phaser 3610, WorkCentre 3615 Service Manual1-4
Safety
The following are hazards to your safety:
• A power cord that is damaged or frayed.
• Liquid that are spilled onto or into the printer.
• A printer that is exposed to water.
If any of these conditions occur, do the following:
1. Turn Off the printer immediately.
2. Disconnect the power cord from the electrical outlet.
Power Safety Precautions
Power Source
For 120 VAC printers (110-127v), do not apply more than 127 volts RMS between the supply
conductors or between either supply conductor and ground. For 230 VAC printers (220-240v), do not
apply more than 240 volts RMS between the supply conductors or between either supply conductor
and ground. Use only the specified power cord and connector.
Power Source information is listed on the data plate on the back of every machine.
Plug the three-wire power cord (with grounding prong) into a grounded AC outlet only. If the product
loses its ground connection, contact with conductive parts may cause an electrical shock. A protective
ground connection by way of the grounding conductor in the power cord is essential for safe operation.
Disconnecting Power
WARNING: Turning the power Off using the power switch does not completely de-energize the
printer. You must also disconnect the power cord from the printer’s Alternating Current (AC) inlet.
Disconnect the power cord by pulling the plug, not the cord.
Disconnect the power cord in the following cases:
• if the power cord or plug is frayed or otherwise damaged,
• if any liquid or foreign material is spilled onto or into the printer,
• if the printer is exposed to any excess moisture,
• if the printer is dropped or damaged,
• whenever you clean or service the product.
To Next Page
Loading...
Need help?
General
